80 Removing and Installing Parts
6
Align the drive screw holes with the screws projecting up on the heat sink holder.
7
Firmly press on the blue tab on each side of the drive until you hear a click.
8
Replace the computer cover ("Replacing the Computer Cover" on page 96).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
9
Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for
drive operation.
1 tabs (2) 2 hard drive
3 hard drive holder on the chassis 4 hard drive plastic latch
1
2
3
4
To Next Page
Loading...
