Removing and Installing Parts 79
3
Connect the power cable and hard-drive or SATA cable to the drive.
4
Check all connectors to be certain that they are properly cabled and firmly seated.
5
Gently slide the drive into the open bay until the hard drive plastic latch attaches to the hard drive
holder on the chassis.
NOTE: The plastic latch fits into a small rectangular hole on the chassis. The rectangular hole is larger than the
other small holes on the back of the chassis.
1 power cable 2 hard drive plastic latch
3 hard drive cable or serial ATA data cable 4 open bay
3
1
2
4
To Next Page
Loading...
