Adding and Replacing Parts 141
1
Follow the procedures in "Before You Begin" on page 131.
2
Turn the computer over and loosen the four captive screws along with the
M2.5 x 5-mm screw. Remove the module cover.
NOTICE: To prevent damage to the memory module connector, do not use tools to
spread the memory module securing clips.
3
Use your fingertips to carefully spread apart the securing clips on each end
of the memory module connector until the module pops up.
4
Remove the module from the connector.
1 M2.5 x 5-mm screw 2 captive screws (4)
1 2
book.book Page 141 Friday, November 30, 2007 11:28 AM
To Next Page
Loading...
