Rev 1 - October 2023
meter will beep. A held reading can be saved, if desired (see
below). Saving a reading or pressing the Read button a second
time will return the meter to live reading mode.
Save a Reading: Press the Center button to save a live or held
reading. This will store the reading, material temperature, and pin
correction type to meter memory. A ‘Saved’ message will appear
followed by the memory slot which the reading occupies (ex. HAY
2/100). This message can be bypassed by pressing the Read
button.
Memory: There are 100 memory slots available in the meter. As
readings are saved, the memory slots will fill in order from lowest
(1) to highest (100). After 100 readings are stored, newly saved
readings will replace the oldest stored readings.
2. Set Point
Info: The Set Point is the user-selectable moisture level at which the
alarm will sound. This feature allows users to take readings without
having to review each one individually, helping to quickly identify
high moisture areas.
Use: When active, press the left and right buttons to adjust the Set Point
down or up. Holding the left or right buttons will cause the Set
Point to change more rapidly.
The Set Point alarm can be turned off by adjusting the set point
value to zero (--.-).
To Next Page
Loading...
Need help?
General
