Rev 1 - October 2023
6. Stats Menu
Figure 4: Stats screen components
1. Stats Selection
The stats selection area will display all statistics in a scrollable list (see
Table 3 below). Press the left and right buttons to view statistics.
2. Stats Details
Statistics are calculated from the list of saved readings in meter memory,
and only readings taken within the valid measurement range of the
selected material are used for the calculations. Out of range readings
will not be included in statistical calculations for average and standard
deviation.
The meter provides statistics (average, high, low, standard deviation) for
the readings that are currently stored in the meter. Note: The statistics in
the meter are calculated without any out of range readings.
The stats details section can only be selected for the ‘View Data’ and
‘Erase Data’ options. For these two cases, press the down or center
buttons to enter stats details box from stats selection. Use the left and
right buttons to scroll the list of latest readings or select the desired
To Next Page
Loading...
Need help?
General
