23
• to exit the steam function, press any button. The
and lights flash to indicate that the temperature is
too high to make coee (see section "Cooling the boiler”).
You should not deliver steam for more than
60 seconds.
7. MAKING HOT MILK
To make hot milk without froth, proceed as described in the
above section, making sure the cappuccino maker selection
ring (A14) is positioned upwards in the "HOT MILK" position.
8. CLEANING THE CAPPUCCINO MAKER
AFTER
USE
Important:
For hygiene reasons, the cappuccino maker should always be
cleaned after use.
Proceed as follows:
1. Turn the steam dial to deliver a little steam for a few sec-
onds (points 2, 5 and 6 of the previous section). This caus-
es the cappuccino maker to discharge any milk left inside.
Press the ON/OFF button to turn the appliance o.
2. Wait a few minutes for the cappuccino maker to cool down.
With one hand, hold the cappuccino maker tube firml ,
with the other, release the cappuccino maker by turning it
clockwise, then pull off d wnwards (fi . 17).
3. Remove the rubber steam connection nozzle from the
spout by pulling it downwards (fi . 18).
4. Push the ring upwards and make sure the two holes shown
by the arrows in fi . 19 are not blocked. If necessary, clean
with a pin;
5. Replace the nozzle, move the ring downwards and put the
cappuccino maker back on the connection nozzle, turning
it and pushing it upwards until it is attached.
9. COOLING THE BOILER
To make coee again immediately after frothing milk, the boil-
er must first be cooled or the coee will be burnt. Proceed as
follows:
• place a container under the cappuccino maker;
• open the steam dial to deliver hot water and cool the
boiler;
• hot water delivery is interrupted automatically when the
boiler is cool. When the pump stops operating and no more
water is delivered, close the steam dial.
The coee maker is now ready for use.
10. HOT WATER
1. Press the ON/OFF button (fi . 3) to turn the appliance on.
Wait for the coee lights to come on steadily.
2. Place a recipient under the cappuccino maker.
3. Turn the dial to the position. Hot water is delivered
from the cappuccino maker.
4. To stop hot water delivery, close the dial and press any
button.
You should not deliver hot water for more
than 60 seconds.
11. CLEANING
11.1 Cleaning the machine
The following parts of the machine must be cleaned regularly:
- drip tray (A9)
- the coee fil ers (C2, C3 and C4);
- the boiler outlet (A5);
- water tank (A3);
- the cappuccino maker (A15) as described in section "”8.
Cleaning the cappuccino maker after use”;
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the coee machine.
• Do not use metal objects to remove encrustations or coee
deposits as they could scratch metal or plastic surfaces.
•
If the appliance is not used for more than one week, before
using it again, we strongly recommend you perform a rinse
cycle as described in section “3. first us ”.
Danger!
• While cleaning, never immerse the coee maker in water.
It is an electrical appliance.
• Before cleaning the outside of the appliance, turn it o,
unplug from the mains socket and allow to cool.
11.2 Cleaning the drip tray
Important!
The drip tray is fit ed with a level indicator (red) showing the
level of water it contains (fi . 20). Before the indicator protrudes
from the cup tray, the drip tray must be emptied and cleaned
otherwise the water may overfl w the edge and damage the
appliance, the surface it rests on or the surrounding area.
1. Remove the drip tray (fi . 21).
2. Remove the cup tray (A7), empty the water and clean the
drip tray with a cloth, then reassemble the drip tray. Ex-
tract the mugs or glasses tray (A10), clean with water, dry
and put back in the machine;
3. Put the drip tray back in place.