EasyManua.ls Logo

DeLonghi ECAM22110SB - Turning the Appliance; Turning the Appliance off; Auto-Off; Energy Saving

DeLonghi ECAM22110SB
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
1� Remove the water tank, ll to the MAX line with fresh
water (g� 1A) then put back in the appliance (g� 1B)�
2� Place a container with a minimum capacity of 100 ml
under the cappuccino maker (g� 2)�
3� Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(g� 3)�
4� The
light ashes on the control panel (g� 4)�
5� Turn the steam dial to the “I” position (g� 5)� The
appliance delivers water from the cappuccino maker then
goes o�
6� Turn the steam dial to the “0” position�
The coee maker is now ready for normal use�
Please note :
• When using the appliance for the rst time, you need to
make 4-5 cups of coee or 4-5 cappuccinos before the
appliance starts to give satisfactory results�
TURNING THE APPLIANCE ON
Please note :
• Before turning the appliance on, make sure the main
switch on the back of the appliance is in the I position (g�
3)�
• Each time the appliance is turned on, it performs an
automatic preheat and rinse cycle which cannot be
interrupted� The appliance is ready for use only after
completion of these cycles�
Danger Of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath�
Avoid contact with splashes of water�
• To turn the appliance on, press the
(g� 6): The
corresponding
light ashes while the appliance is
heating up and performing an automatic rinse cycle (by
circulating hot water, the appliance heats both the boiler
and the internal circuits)�
The appliance is at temperature when the
light goes o and
the lights corresponding to the coee buttons come on�
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted�
Danger Of burns!
During rinsing, a little hot water ows from the coee spouts�
Avoid contact with splashes of water�
To turn the appliance o, press the
button (g� 6)� The
appliance performs a rinse cycle, then goes o�
Please note :
If the appliance is not used for an extended period, also place
the main switch in the 0 position (g� 3)�
Important!
To avoid damaging the appliance, do not place the main switch
(g� 3) in the 0 position until the appliance has been turned o
using the button�
AUTOOFF
The appliance is set to turn o automatically if not used for 2
hours�
The time can be changed so that the appliance switches o
after 15 or 30 minutes, or after 1, 2 or 3 hours�
The set the auto-o, proceed as follows:
1� With the machine o and the main switch in I position
(g� 3), press the
button and keep it pressed until the
lights on the control panel come on�
2� Press the button (on the left side of the dial) until
the lights corresponding to the number of hours before
the appliance goes o automatically come on:
15 minutes ECO
30 minutes ECO
1 hour ECO
2 hours ECO
3 hours ECO
3� Press the button (on the right side of the dial) to
conrm; the lights switch o�
ENERGY SAVING
Use this function to enable or disable energy saving mode�
When enabled, the function reduces energy consumption in
compliance with European regulations�
Energy saving mode is active when the green ECO light is on
(g� 7)�
1� With the appliance o and the main switch in the I
position (g� 3), press the
button and hold it down
until the ECO light comes on (g� 7)�
2� To disable the mode, press the button (on the left of
the dial)� The ECO light ashes�
3� To re-enable the mode, press the ECO button (on the left
of the dial) again� The ECO light comes on steadily�
4� Press the button (on the right of the dial) to