DeLonghi ECAM22110SB - Water Softener Filter; Installing the Filter; Removing and Replacing the Filter; Making Coffee

11
conrm the selection� The ECO light goes o�
Please note :
A few seconds may elapse between energy saving mode
and delivery of the rst coee as the appliance must heat up
again�
WATER SOFTENER FILTER
Certain models are tted with a water softener lter� If this
is not the case with your model, you are recommended to
purchase one from De’Longhi Customer Services�
Important:
• Keep in a cool dry place out of direct sunlight�
• After opening the package, use the lter at once�
• Remove the lter before descaling the machine�
To use the lter correctly, follow the instructions below�
Installing the lter
1� Remove the lter from packaging and rinse the lter with
about half a liter of tap water (g� 8)�
2� Rotate the calendar disk so that the next two months are
displayed (g� 9)�
Please note:
The lter lasts about two months if the appliance is used
normally� If the coee maker is left unused with the lter
installed, it will last a maximum of three weeks�
3� Remove the tank from the appliance and ll with water
(g� 1A)�
4� Insert the lter in the water tank and immerse it
completely, sloping it to enable the air bubbles to escape
(g� 10)�
5� Insert the lter in the lter housing and press as far as it
will go (g� 11)�
6� Close the tank with the lid (g� 12), then replace the tank
in the machine�
7� Place a container (min� capacity: 100 ml) under the
cappuccino maker�
8� Turn the steam dial in position I to deliver hot water�
9� Let the appliance deliver hot water for a few seconds, til the
delivery ows regulary, then turn the dial in position 0�
Please note:
It may happen that a single hot water is not sucient to install
the lter: the lghts
come on�
In this case, repeat the installing operation from step 8�
The new lter is active and you can now use the coee maker�
Removing and replacing the lter
After rwo months (see date indicator) or when the appliance
has not been used for 3 weeks, you should remove the lter
and replace with a new one, proceeding as described at the
previous paragraph�
MAKING COFFEE
Selecting the coee taste
Turn the coee taste selection dial (B6) to set the required
taste� Turning it clockwise increases the quantity of coee
beans the appliance will grind and, therefore, the strength of
the coee obtained�
Turn the dial to MIN for an extra mild coee and to MAX for an
extra strong coee�
Please note :
• The rst time you use the appliance, you will need to make
a number of coees to identify the correct dial position
through trial and error�
• Do not turn the dial too far towards MAX, otherwise the
coee may be delivered too slowly (a drop at a time),
particularly when making two cups of coee at the same
time�
Selecting the quantity of coee in the cup
The appliance is set by default to automatically make the
following quantities of coee:
- espresso coee, when the
button is pressed (≃1�35
� oz�);
- long coee when the button (≃4 �oz�) is pressed;
- two espresso coees, when the
button is pressed;
- two long coees, when the
button is pressed�
To change the quantity of coee the appliance delivers
automatically into the cup, proceed as described below:
- press the button corresponding to the quantity to be
modied and hold it down until the light ashes and the
appliance starts delivering coee� Release the button;
- when the coee in the cup reaches the required level, press
the same button again to memorize the new amount�