Dishwashing is recommended: when a dishwasher is not available, the Rapid Cappuccino System components can be washed by hand. The procedure must be performed
after each use.
1. Disassemble the Rapid Cappuccino System. Refer to section “Assembling / Disassembling of Rapid Cappuccino System”. Rinse away carefully any milk residue with hot
potable water (40°C / 104°F). Remove all the visible dirt with a sponge.
2. Soak all components in with hot potable water (40°C / 104°F) together with mild/soft detergent for at least 30 minutes and rinse thoroughly with hot potable water (40°C /
104°F). Do not use odor mild/soft detergents.
3. Clean the interior of the milk tank, the milk spout connector, and the milk knob with mild/ soft detergent and rinse with hot potable water (40C/104F).
* Ensure air inlet is clean. This will ensure perfect foam.
Do not use abrasive material that might damage the surface of the equipment.
4. Dry all parts with a fresh and clean towel, cloth or paper and reassemble. If the Rapid Cappuccino System was very dirty, proceed with two rinsing of the system by turning the
milk froth regulator knob to (Clean) position. Milk system rinsing process starts and hot water combined with steam flows through the milk spout.
To Next Page
Loading...
Need help?
General
