13
P
ROGRAMMING THE TIMER
The timer can be programmed to start up and shut down to fit in
with your needs.
Programming start up
•Press the ON button. The start-up time and message "ON
TIMER" flash on the remote control display (fig. 24).
•Press the or buttons to set the time you want the
appliance to start up.
• When that time is reached, press the SET button to confirm
(fig. 25). The message "ON TIMER" appears on the remote con-
trol display and the symbol is displayed on the appliance
to indicate that the timer is active.
Programming shutdown
•Press the OFF button. The shutdown time and the messa-
ge "OFF TIMER" flash on the remote control display (fig. 26).
•Press the or buttons to set the time you want the
appliance to shut down.
• When that time is reached, press the SET button to confirm
(fig. 27). The message "OFF TIMER" appears on the remote
control display and the symbol is displayed on the applian-
ce to indicate that the timer is active.
24
25
26
27
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
IF ...
IS DISPLAYED, WHAT
SHOULD I DO?
LOW TEMPERATURE
(frost prevention)
PROBE FAILURE
(sensor damaged)
The appliance is fitted with
a frost protection device to
avoid excessive formation
of ice.
The appliance starts up
again automatically when
the defrosting process is
completed.
If this is displayed, contact
your local authorised servi-
ce centre.
IF ...
IS DISPLAYED, WHAT
SHOULD I DO?
FULL TANK
(tanica piena)
FAILURE 1
(pump failure)
Empty the tank on the back of
the appliance and replace it
correctly.
The continuous drain hose is
not connected correctly or is
obstructed and the air condi-
tioner is draining into the tank.
NB: in dehumidifying mode, it is
normal for this message to
appear when the continuous
drain house is not connected.
If this is displayed, contact
your local authorised servi-
ce centre.
To deactivate the timer, press the
relative timer button ( ON or
OFF) twice.
To Next Page
Loading...
