Delphi Connect User Manual

11
Step 5: Initiate Module Setup
Stop! Do not proceed until the Status LED is solid
blue, indicating activation on the Verizon network.
•Insertyourvehicle’signitionkeyandturnit
to the on position (not ACC/Accessory). Do
not start the engine!
- Typically, all of the warning lamps on the
dashboard will illuminate briefly in this position
- For pushbutton-start vehicles, the procedure is
typically to push the start button without your
foot on the brake (check your vehicle owner’s
manual to determine how many presses are
required to turn the ignition on).
• PressandholdtheFunctionButtononthesideof
the module until the Status LED blinks red one
time. This will occur after approximately
5 seconds. Then release the Function Button. The
LED will blink red while vehicle setup occurs.
• Waitupto30secondsfortheLEDtodisplayamix
of solid and blinking green.

Delphi Connect Specifications

General

Brand	Delphi
Model	Connect
Category	Diagnostic Equipment
Language	English