Basic Operations
Turning Roady On and Off
Press on the Roady Receiver. When first turned on, the receiver will
automatically tune in to the last channel listened to and recall the previous
settings.
Basic Channel Selection
Select a channel by number
1. Verify that Roady is in Direct Entry mode. “Direct” should appear in the
upper right corner of the display. If A, B, or C appears, press until the
display says “Direct.”
2. Enter channel number using the number keys, i.e., 5 + 0 for Channel 50.
Set/select channel presets
Your Roady Receiver can store up to 30 preset channels. They are organized
into three different groups (Preset A, Preset B, and Preset C), each with 10
channels corresponding to the 10 number keys. For preset 10, you only
need to press “0.”
Selecting channel presets
Press until an A, B, or C appears in the upper right corner of the
display. Press the number key corresponding to the desired preset.
Setting channel presets
1. Tune in the channel you want to register as a preset, making sure it is playing.
2. Select either Preset A, Preset B, or Preset C by pressing until an A,
B, or C appears in the upper right corner of the display.
Section 3
To Next Page
Loading...
Need help?
General
