7. Reassemble the system as in step 1, inserting cassette audio adaptor
into the vehicle’s cassette deck and the 12V power adaptor into the
cigarette lighter.
8. Attach the antenna as explained on page 20.
Removing car mount from your dashboard
You can remove the car mount from your dashboard by taking the
following steps:
1. Lift one edge of the adhesive pad gently with fingers or the rounded edge of a
spoon. Once enough of the edge is loosened to grip with your fingers, pull the
pad gently from the mounting surface at a 90-degree angle. Avoid using
sharp tools that could damage the vehicle’s interior.
2. If the pad fails to loosen, first warm it with a hair dryer for 2 to 3 minutes to
soften the adhesive. Be careful not to apply too much heat, which could
damage the mounting surface.
3. If any adhesive remains on the dashboard surface, the adhesive can easily be
removed by rubbing your thumb or finger across it.
4. As necessary, use a mild household cleaner to clean the dashboard surface.
Caution: Never use a commercial heat
gun or paint-stripping gun. This could result in
damage to the unit or to your vehicle.
19
To Next Page
Loading...
Need help?
General
