EasyManua.ls Logo

Delphia 33 - Anti Corrosion Securings Control Processes

Default Icon
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
.
Wedonotneedtosay howimportant isefficientcathode protectionto
mantaina goodtechnical conditionofpropeller.Regular controlofprotectors
(anode) isnecessary beforethestart ofsailing season and inthemiddleofit.Itisalso
advised tochecktheefficiencyofcathode protectionbydoingelectricmeasurements
(refertocontrolprocessesbelow).Incase whenthevolumeofprotectorsisreduced
byhalf, theyshouldbereplaced withnewones.Iftheconsumptionisnotsignificant,
youcan leave thesame protectorsforthenextseason. Inordertogetmoredetailed
information concerningthereplacement oftheanode youshouldrefertomanual
whichisattachedtotheengine
ANTICORROSIONSECURINGSCONTROLPROCESSES:
-
( 1).
m
checkifthereisnoelectricpassageinS-driveengine,thismeans:with12Vmaster
switchesturnedofftouchtheenginecolumnwithonetesterpinandthegearboxwith
thesecondpin photo Ifthetestershowsany
value(differentfromthetheoneonthephoto)
thismeansthatthereiselectricpassagebetween
thecolu nandthegearbox.Thisproblemshould
beimmediatelyreportedtothedealerortheengine
manufacturer.
- checkthegalvonicinsulatorwhichisinstalledintherightsternlocker
photo in circuitprotectioncable
betweenthepowerdockanddifferentialcircuit
breakerIfthetestershowsthevalueasonthe
photo,thismeansthattheinsulatorworks
properly.Incasewhentheresultisdifferent,this
meansthatthegalvonicinsulatordoesnotwork
properly.
( 2), 115/230V
.
Inbothsituationstheswitchof
thetestershouldbepostioned
aspresentedonthephoto
(0-200).
1
2
59/99
ATTENTION!
Onsaltwatersyoushouldusezincanodesandonfreshwatersyou
shouldusemagnesiumanodes.

Table of Contents