Delphia 33 - Boat Launching Procedures

10
90/99
LAUNCHING
A very important operation is the initial launching of the boat. aThis launching
heowner
oftheboat willberesponsiblefore
nd
the first tests of different equipment shall be carried out in the presence of yor
dealer. Onlythenthewarrantymay coverthenoticedequipmentfailure. T
verynextlaunching.
BEFORELAUNCHING
-
-
-
checkthewaterintakes
turnofftheenginecoolingwaterdrainvalve
turnoffallthewaterinletanddrainvalves(sink,toilet,shower)
HOISTINGTHEBOAT
- ( ).
-
( )
-
-
.
-
Installtworopes foreandrear
Installthecranebeltsonthepositions(justunderthefenderbar)
photo .
Checkthatnodeviceiscrushedbythebelts.
Thebeltsshouldnotbehookeddirectlyonthecranehookbecauseitmayresultin
unusualcompressivestressesonthehullInsteaduseagantryoraspacerwithtwo
belts.
Hoisttheboatslowly.Controlthemovementsoftheboatswithropes.
markedwith
stickers
ATTENTION !
Donotstayonboardorundertheboatduringhoisting.
AFTERLAUNCHING
-
-
Openthevalvesandmakesurethatnoneofelementsweredamagedduring
launching.
Beforestartingtheenginerefertochapter9 “Engine”.
Themarkingofthecrane
beltsplacement