8
ADJUSTMENTS
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
1. For rapid adjustment of the work support plate (A)
Fig. 20, loosen lock knob (B), hold down quick release
button (C), and move jig (D) as necessary. Tighten lock
knob (B) and let loose of quick release button (C) after
adjustment is made.
2. Fine adjustment of the work support plate (A) Fig. 20,
can be accomplished by loosening lock knob (B) and
rotating knob (E) until plate (A) is at the desired position.
Tighten knob (B) Fig. 20, after fine adjustment is made.
Each index mark on (E) Fig. 20 is approximately to .004",
a full rotation of knob (E) is approximately 1/16".
3. To tilt the vertical work support plate (A) Fig. 20,
loosen lock knob (F), tilt vertical work support plate to
the desired angle and tighten lock knob (F).
4. To adjust backstop (G) Fig. 21, for angled tenons,
loosen lock knob (H), adjust backstop (G) to the desired
angle and tighten knob (H).
5. IMPORTANT: THE TENONING JIG IS NOT EQUIP-
PED WITH A BEVEL SCALE FOR THE POSITIONING
OF BACKSTOP (G) FIG. 21, OR SUPPORT PLATE (A)
FIG. 20. FOR THE DESIRED ANGLE, THE WORK-
PIECE SHOULD BE CUT PRIOR TO THE SET UP OF
THE JIG AND USED AS THE ANGLE REFERENCE.
Fig. 20
Fig. 21
A
C
E
B
F
D
G
G
H
To Next Page
Loading...
Need help?
General
