Need help?Do you have a question about the Delta 422-04-651-0027 and is the answer not in the manual?
Specific safety guidelines for operating circular saws, covering guards, push sticks, and avoiding kickbacks.
Essential steps for properly grounding the saw to protect the operator from electric shock.
Connecting and operating the saw with a 3 HP single-phase, 220-240V motor.
Connecting and operating the saw with a 5 HP single-phase, 220-240V motor.
Procedures for powering the machine on and off using the start and stop buttons.
Operation and adjustment of the front handwheel for raising and lowering the saw blade.
How to tilt the saw blade to desired angles up to 45 degrees using the handwheel.
Calibrating the positive stops for accurate 90 and 45 degree blade angle settings.
Using and adjusting the rip fence for precise parallel cuts.
Technique for making cuts across the grain using the miter gage for guidance.
Technique for making lengthwise cuts along the grain using the rip fence for guidance.
Common causes and checks for when the machine fails to start, including power and fuses.
To Next Page
General
