Delta 36-441B User Manual

INSTRUCTION MANUAL
To learn more about DELTA MACHINERY
visit our website at: www.deltamachinery.com.
For Parts, Service, Warranty or other Assistance,
please call
1-800-223-7278 (In Canada call 1-800-463-3582).
10" Contractor’s Saw
(Models 36-441B, 36-451X)
PART NO. 422-19-651-0058 - 03-22-04
Copyright © 2004 Delta Machinery
NOTE: Shown with UniRip
®
Fence System

Delta 36-441B Specifications

General

Type	Table Saw
Blade Diameter	10 inches
Motor Power	1.5 HP
Motor	Induction
Voltage	120 V
Table Size	20 x 26 in
Max Rip Right	30 inches
Max Rip Left	12 inches
Max Depth of Cut at 90 Degrees	3-1/8 inches
Max Depth of Cut at 45 Degrees	2-1/4 inches
Max Cut Depth at 90°	3-1/8 inches
Max Cut Depth at 45°	2-1/4 inches
Weight	56 lbs
No-Load Speed	5000 RPM
Arbor Size	5/8 inches

Summary

10" Contractor's Saw Instruction Manual

Safety Guidelines and Definitions

General Safety Rules

Important Safety Instructions

Crucial advice on safe operating procedures, including the use of safety equipment.

Power Connections and Grounding

Grounding Instructions

Specific guidance on grounding the machine to prevent electric shock hazards.

Saw Assembly and Stand Mounting

Assembling Saw to Stand

Details the process of securely mounting the saw unit onto its assembled stand.

Motor and Blade Tilting Handwheel Assembly

Assembling Motor to Mounting Plate

Mounting Motor Assembly to Saw

Motor Pulley, Belt, and Guard Installation

Connecting Motor to Switch Assembly

Blade Guard and Splitter Assembly

Aligning Splitter Bracket

Guidance on ensuring proper alignment of the splitter with the arbor flange.

Blade Guard and Splitter Alignment Procedures

Final Blade Guard and Insert Installation

Extension Wing and Switch Installation

Stand Securing and Saw Operation Controls

Starting and Stopping Saw Operation

Locking Switch in Off Position

Blade Height, Tilt, and Angle Adjustments

Adjusting Blade Height and Tilt

Setting 90 and 45 Degree Positive Stops

Saw Blade Alignment Procedures

Checking Blade Alignment

How to verify the parallelism of the saw blade to the miter gage slots.

Adjusting Blade Alignment

Procedures for making adjustments to the trunnion mounting bolts for blade alignment.

Blade Mechanism Adjustments and Blade Replacement

Backlash Adjustments for Blade Mechanisms

Changing the Saw Blade

Step-by-step guide for safely replacing the saw blade.

Table Insert and Miter Gage Adjustments

Miter Gage Operation and Calibration

Common Sawing Operations Overview

Cross-Cutting Procedures

Ripping Operations Guide

Safe Ripping Techniques