To Next PageTo Next Page
Need help?Do you have a question about the Delta 36-220 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Motor Power | 1.5 HP |
| Voltage | 120 V |
| Blade Diameter | 10 inches |
| Bevel Capacity | 45 degrees |
| Miter Capacity | 45 degrees |
| Arbor Size | 5/8 inches |
| Max. Rip Left of Blade | 12 in |
| Table Size | 20 x 27 inches |
| Max. Depth of Cut at 45 Degrees | 2-1/4 in |
Essential guidelines for safe operation, including tool handling, work area, and environment.
Mandatory use of safety glasses, proper apparel, and hair covering to prevent injury.
Ensures a safe workspace, addresses health hazards from dust, and proper ventilation.
Rules for safe blade use, guard engagement, workpiece handling, and proper cutting techniques.
Guidelines for securing workpieces, using correct materials, and maintaining a safe work environment.
Procedures for safe servicing, adjustment, and cleaning of the saw, including electrical disconnect.
References to safety standards and organizations for additional information.
Details on required voltage, AC current, motor speed, and safe connection procedures.
Guidance on choosing the correct gauge and length of extension cords for optimal performance.
Introduction to the saw's features and instructions for safely removing it from packaging.
Important warnings and steps before beginning the assembly process.
Step-by-step instructions for assembling the lower blade guard link for safety.
Procedure for attaching the stock stop and table extensions for workpiece support.
Instructions on how to install and properly position the work clamp for secure material holding.
Steps for attaching the dust bag to the saw's dust spout for dust collection.
Guidance on securely mounting the miter saw to a workbench for stability and safety.
Identifies the designated hazard zone on the saw table and warns against placing hands inside.
Explains how to turn the saw on and off, including the function of the automatic electric brake.
Warning regarding potential loosening of the arbor screw due to braking torque.
How to set miter angles, use positive stops, and tighten the lock handle.
Procedure for tilting the cutting arm to set bevel angles and use positive stops.
Instructions on how to lock the cutting arm in the down position for safe transportation.
Guidance on changing the fence from the forward to the rear position for different cuts.
Procedure for adjusting the 90 and 45 degree bevel stops for accurate angle settings.
Instructions to ensure the saw blade is parallel to the table insert slot for precise cuts.
Procedure to adjust the fence to be 90 degrees to the blade in the forward position.
Procedure to adjust the fence to be 90 degrees to the blade in the rear position.
How to adjust the sliding fit of the cutting arm for smooth and accurate vertical movement.
Adjusting the blade's downward travel to prevent contact with machine parts.
Steps for preparation before cutting, including setting angles and securing workpieces.
Tips on cutting rate, using the fence, stock stop, and work clamp for efficient cuts.
Illustrations showing the use of work clamp and fence for various cutting operations.
Visual guide for performing a compound miter and bevel cutting operation.
Examples demonstrating cross-cutting standard lumber sizes using the fence.
Detailed steps for cutting inside and outside corners of crown moulding accurately.
Instructions for mounting and using an auxiliary wood fence for small cut-off pieces.
Comprehensive guide on safely removing and installing the saw blade.
Procedure for inspecting and replacing worn motor brushes to ensure proper function.
Information on where to obtain a complete line of available accessories for the saw.
Contact details for obtaining parts, service, warranty assistance, and support.
Details of the two-year limited warranty, including coverage and exclusions.
List of Porter-Cable/Delta service center locations across the United States.
List of Porter-Cable/Delta service center locations in Canada.
Listing of registered and unregistered trademarks associated with Delta machinery.
