To Next PageTo Next Page
Need help?Do you have a question about the Delta 36-225 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Motor Power | 1.5 HP |
| Motor | Induction |
| Voltage | 120 V |
| Table Size | 27 x 40 inches |
| Max Depth of Cut at 90 Degrees | 3-1/8 inches |
| Max Depth of Cut at 45 Degrees | 2-1/4 inches |
| Arbor Size | 5/8 inches |
Emphasizes hazards from not following safety rules, leading to potential injury.
Covers using correct blades, ensuring sharpness, and avoiding damaged parts for safe operation.
Explains the necessity of grounding for electric shock protection and proper connection procedures.
Warns against connecting power until assembly is complete and provides steps for moving the cutting head.
Identifies a specific hazard zone on the table and warns against placing hands inside it during operation.
Explains how to start and stop the saw using the switch trigger and mentions the electric blade brake.
Details how to adjust the table for miter cuts, including using positive stops and triangle indicators.
Guides on tilting the cutting head for bevel cuts, using the lock handle and positive stops.
Provides detailed steps for adjusting the 0° positive stop for accurate 90° cuts, affecting all stops.
Details the procedure for adjusting the bevel lock handle and screws for precise 90° and 45° bevel angles.
Explains how to limit blade downward travel to prevent contact with machine surfaces via adjusting screws.
Guides on aligning the saw blade parallel to the table opening's left edge for accurate cuts.
Details the specific miter and bevel angles and procedures for cutting inside and outside crown moulding corners.
