8
FASTENING MACHINE TO SUPPORTING SURFACE
Fig. 9
Before operating your compound miter saw, make sure it is firmly mounted to a sturdy workbench or other supporting
surface. Four holes are provided, two of which are shown at (A) Fig. 9, for fastening the saw to a supporting surface.
When frequently moving the saw from place to place, we suggest that the saw be mounted to a 3/4″ piece of
plywood. The saw can then be easily moved from place to place and the plywood clamped to the supporting
surface using “C” clamps.
A
TABLE HAZARD AREA
WARNING: THE AREA INSIDE THE TWO RED LINES (A) FIG. 9A, ON THE TABLE IS DESIGNATED AS A
HAZARD ZONE. NEVER PLACE YOUR HANDS INSIDE THIS AREA WHILE THE TOOL IS BEING
OPERATED.
Fig. 9A
A
A
To Next Page
Loading...
