7
Fig. 5
ASSEMBLING STOCK STOP
AND TABLE EXTENSIONS
1. Decide on which side of the saw table you want the
stock stop (A) Fig. 5, to be, and assemble stock stop (A)
onto table extension (B), as shown. NOTE: The most
commonly used position of the stock stop will be on the
right hand table extension, as shown.
Fig. 6
Fig. 7
Fig. 8
2. Insert ends of table extension (B) Fig. 6, into the four
holes on end of saw base and into the two holes of lock
bracket (C), as shown. Tighten screw (D) to hold table
extension in place.
3. Assemble left hand table extension (E) Fig. 7, in the
same manner.
4. Fig. 8, illustrates both the right and left hand table
extensions (B) and (E) assembled to the saw and the
stock stop (A) assembled to the right hand table exten-
sion.
A
B
B
C
D
E
E
B
A
To Next Page
Loading...
