To Next PageTo Next Page
Need help?Do you have a question about the Delta 36-979 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Voltage | 120 V |
| No-Load Speed | 5000 RPM |
| Blade Diameter | 10 inches |
| Arbor Size | 5/8 in |
| Max. Depth of Cut at 90 Degrees | 3-1/8 inches |
| Max. Depth of Cut at 45 Degrees | 2-1/4 inches |
| Dust Port Size | 2-1/2 inches |
Warning about chemicals linked to cancer and birth defects.
Safety instructions for using the blade guard and splitter.
Critical safety guidelines for tool operation.
Importance of using all safety features to prevent kickback.
Techniques and precautions to prevent kickback during operation.
Essential steps for proper grounding of electrical connections.
Introduction to the saw's features and capabilities.
List of tools needed for assembly.
Estimated time required for assembly.
Instructions for assembling front and side panels of the stand.
Steps for attaching leg supports to the stand base.
How to attach corner brackets to the stand.
Instructions for installing and adjusting leveling feet.
How to attach wheels to the mobile base.
Steps to attach the foot lever mechanism to the base.
Installing plastic feet on the stand.
Guidance on installing an optional shelf for the saw.
How to attach the dust chute and back brace.
Connecting the mobile base and stand to the main saw unit.
Installing the handwheels for blade adjustment.
Attaching the hook for storing wrenches.
Mounting the motor onto its supporting plate.
Connecting the motor assembly to the saw body.
Installing the motor, pulley guide, and drive belt.
Attaching the protective belt guard.
Wiring the motor cord to the switch.
Steps to remove the motor for moving the saw.
Assembling and aligning the blade guard and splitter.
Procedures for adjusting the table insert for proper fit.
Instructions for attaching extension wings to the saw table.
Overview of controls and adjustments for operating the saw.
Procedures for starting and stopping the saw safely.
How to secure the switch in the off position for safety.
Understanding and resetting the motor overload protection.
How to adjust the blade height using the handwheel.
Adjusting the blade angle for bevel cuts.
Setting the positive stops for common angles.
Using and adjusting the miter gauge for cuts.
Fine-tuning the table insert for a flush fit.
Ensuring miter slots are parallel to the saw blade.
Step-by-step guide for safely replacing the saw blade.
Adjusting mechanisms for blade movement to eliminate play.
Pre-operation checklist for safety and readiness.
Identification of major components and safety features.
Proper usage of the blade guard and splitter for safety.
Technique for performing cross-cuts using the miter gauge.
How to use the fence for cross-cutting operations.
Performing cross-cuts at an angle.
Combined bevel and miter cuts on the saw.
How to perform ripping operations using the rip fence.
Instructions for making a safety push stick.
Instructions for using a moulding cutterhead attachment.
Guidance on using specific moulding cutterhead accessories.
Instructions for using a dado head attachment.
How to perform dado cuts with the attachment.
How to use auxiliary wood facing for specialized operations.
Procedures for cleaning the machine to maintain performance.
Methods for lubricating parts and preventing rust.
Maintenance of blade adjustment mechanisms.
