To Next PageTo Next Page
Need help?Do you have a question about the Delta UNISAW 36-953 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Arbor Size | 5/8 inches |
| Maximum Depth of Cut at 90 Degrees | 3-1/8 inches |
| Maximum Depth of Cut at 45 Degrees | 2-1/4 inches |
| Voltage | 120/240 V |
| Amps | 15/7.5 A |
| No Load Speed | 3450 RPM |
| Max Rip Capacity | 30 inches |
| Motor | 120/240V |
| Table Size | 27 inches |
General warnings and operating instructions for safe use of the machine.
Explanation of safety symbols, warnings, and definitions used in the manual.
Essential safety precautions for operating power tools and machinery.
Specific safety precautions applicable to table saw operation.
Guidance on connecting the machine to appropriate electrical power sources.
Details on motor ratings, voltage, horsepower, and frequency.
Essential steps for proper machine grounding to prevent electric shock.
Recommendations for selecting and using appropriate extension cords for the machine.
Introduction to the saw, manual overview, and list of all parts.
Required tools, unpacking instructions, and initial setup steps.
Step-by-step instructions for assembling the blade tilting handwheel.
Instructions for attaching the left and right extension wings to the saw table.
Procedures for mounting the starter box and connecting the on/off switch.
Steps for installing the blade guard and splitter assembly.
Instructions for attaching the motor cover and rip fence holder brackets.
Guidance on installing the dust chute connector for dust collection.
Overview of the saw's controls, start/stop, overload protection, and locking switch.
How to raise, lower, and tilt the saw blade to desired angles.
Adjusting 90/45 degree stops and checking saw table alignment.
Using and adjusting the miter gage for precise cuts.
Procedures for changing the saw blade and adjusting belt tension.
Introduction to common sawing operations like ripping and crosscutting.
Safe and proper methods for performing cross-cuts using the miter gage.
Safe and proper methods for performing ripping operations with the fence.
Instructions for constructing and using featherboards and push sticks.
Using the moulding cutterhead for shaping wood edges.
Using the dado head set for cutting grooves and joints.
Procedures for keeping the machine clean and resolving common issues.
How to obtain parts, service, and warranty assistance.
Information on available accessories for the saw.
Information regarding the product's limited warranty terms.
