To Next PageTo Next Page
Need help?Do you have a question about the Delta Unisaw 36-841 and is the answer not in the manual?
General| Type | Cabinet Saw |
|---|---|
| Blade Diameter | 10 inches |
| Arbor Size | 5/8 inches |
| Weight | 267 lbs |
| Rip Capacity | 52 inches |
| Maximum Depth of Cut at 90 Degrees | 3-1/8 inches |
| Rip Capacity to the Left of the Blade | 12 inches |
| Bevel Range | 0 - 45 degrees |
| Table Size | 27 x 40 inches |
| Dust Collection | 4-inch port |
| Maximum Depth of Cut at 45 Degrees | 2-1/4 inches |
Critical warning about severe injury from not following safety rules.
Warning about severe injury if circular saw safety rules are not followed.
Warning against operating the machine in wet or damp conditions.
Mandatory grounding warning for operator protection from electric shock.
Ensuring the electrical receptacle is properly grounded is essential.
Introduction to the Limited Edition 10" Unisaw and its capabilities.
Instructions for safely unpacking and cleaning the machine and its components.
Safety warning: Do not connect power until the saw is fully assembled and manual is understood.
Step-by-step guide to assembling the blade tilting mechanism's handwheel.
Caution to disconnect power before starting blade guard and splitter assembly.
Instructions on how to detach the motor cover from the saw.
Steps for correctly mounting the motor cover onto the saw.
Important note: Do not mount dust chute adapter without a dust collection system.
Steps to assemble the guide rails for the Biesemeyer fence system.
Instructions on how to start and stop the Unisaw machine.
How to secure the switch in the OFF position using a padlock for safety.
Explanation of the saw's overload protection feature and reset procedure.
How to raise and lower the saw blade using the handwheel.
Instructions for tilting the saw blade to different angles.
Step-by-step instructions for safely replacing the saw blade.
Procedure for replacing belts and setting correct belt tension.
Guide to performing cross-cutting operations using the miter gage.
Critical warning against using the fence for cross-cutting cut-off measurements.
Critical safety warning about kickback when using the moulding cutterhead.
Important note: Blade guard and splitter must be removed for dadoing/moulding.
Warning against using the dado head in a bevel position to prevent injury.
Information on the Delta Model 34-976 Uniguard Blade Guard accessory.
Details on the Biesemeyer Model 78-960 T-Square Table Saw Blade Guard System.
Warning about potential hazards of using non-Delta tested accessories.
