To Next PageTo Next Page
Need help?Do you have a question about the Delta UniSaw 36-L51X and is the answer not in the manual?
General| Type | Cabinet Saw |
|---|---|
| Blade Diameter | 10 inches |
| Motor Power | 1.75 HP |
| Table Size | 40 inches x 27 inches |
| Weight | 250 lbs |
| Voltage | 120V/240V (Prewired 240V) |
| Arbor Size | 5/8 inches |
| Max. Depth of Cut at 90 degrees | 3-1/8 inches |
| Max. Depth of Cut at 45 degrees | 2-1/4 inches |
| Max Rip Capacity | 52 inches |
| Dust Port Size | 4 inches |
| No Load Speed | 4300 RPM |
Defines safety symbols (Danger, Warning, Caution) and addresses California Proposition 65 warnings.
Outlines crucial safety practices for machine operation, including personal protective equipment and work environment.
Details specific safety precautions for table saw use, emphasizing kickback prevention and workpiece control.
Explains the importance of grounding for operator safety and proper connection procedures.
Instructions for removing the table insert and preparing for guard/splitter assembly/alignment.
Details aligning the splitter bracket with the blade flange and attaching the support rod.
Covers inserting the splitter, attaching the blade guard, and checking splitter alignment with the blade.
Final steps for guard/splitter assembly including table insert installation and leveling.
Explains how to start/stop the machine, lock the switch, and details overload protection.
Describes the operation of handwheels for raising, lowering, and tilting the saw blade to specific angles.
Instructions for checking and adjusting the positive stops for accurate blade positioning at 90 and 45 degrees.
Details how to insert, operate, and adjust the miter gage, including its index stops.
