To Next PageTo Next Page
Need help?Do you have a question about the Delta UNISAW 36-L336 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Motor Power | 3 HP |
| Table Size | 40 inches x 27 inches |
| Weight | 300 lbs |
| Voltage | 120V/240V |
| Max. Depth of Cut at 90 Degrees | 3-1/8 inches |
| Max. Depth of Cut at 45 Degrees | 2-1/4 inches |
| Max Cut Depth at 45° | 2-1/4 inches |
| Arbor Size | 5/8 inches |
| Amperage | 15 Amps |
| Max Rip Right of Blade | 36 inches |
| Amps | 15 Amps |
| Phase | Single Phase |
| No Load Speed | 4300 RPM |
Read all warnings and operating instructions before using any tool or equipment.
Defines safety alert symbols like DANGER, WARNING, CAUTION, and NOTICE.
Provides 25 essential safety rules for operating power tools safely.
Details safety precautions specific to table saw operations.
Explains terms like through-cut, non-through-cut, push stick, and kickback.
Describes the function and use of these safety components.
Details electrical requirements for 3HP and 5HP units.
Emphasizes grounding for electrical safety.
Provides guidelines and a chart for selecting the correct extension cord gauge.
Details the saw's capabilities and model-specific specs.
Lists all items included in the product packaging.
Steps for removing packaging and rust preventative oil.
Lists required tools and estimated assembly time.
Guidance on mounting and attaching extension wings.
Installing the switch and anti-kickback/guard components.
Detailed instructions for mounting the blade guard.
Steps for putting the miter gauge together.
How to store the miter gauge and install the reducer.
Guidance on installing the fence system.
How to turn the saw on/off and secure it.
Steps for adjusting blade height.
How to adjust the blade tilt angle.
How to position and adjust the riving knife.
Primary and alternative methods for adjusting the riving knife.
Detailed steps for ensuring proper alignment.
Guidelines for choosing appropriate saw blades.
How to choose the correct riving knife thickness.
Setting blade stops and calibrating the tilt indicator.
Ensuring accurate cuts by aligning slots to the blade.
Adjusting cable, aligning fence, and changing blade.
Setting the maximum cutting depth.
Setting belt tension and operating the blade guard.
Essential safety checks and kickback prevention.
Introduction to ripping and crosscutting.
Guidelines for safe ripping and cutting small pieces.
Performing ripping and crosscutting with beveled blades.
Detailed crosscutting techniques.
Performing miter cuts and using dado heads.
Precautions and configuration for dado heads.
Instructions for using molding cutterheads.
Using wood facing and featherboards.
How to make and use a push stick.
Assistance and cleaning procedures.
Checks for starting issues and table maintenance.
Maintaining parts and replacing belts.
Obtaining parts, service, and warning labels.
Essential safety advice in multiple languages.
Advice on accessories and product warranty details.
