To Next PageTo Next Page
Need help?Do you have a question about the Delta 902118 43-505 and is the answer not in the manual?
General| Brand | Delta |
|---|---|
| Model | 902118 43-505 |
| Category | Power Tool |
| Language | English |
Read manual, check guards, remove keys, clear area, proper attire.
Maintain balance, use right tool, secure work, avoid forcing, operate alertly.
Avoid damp areas, ensure lighting, manage dust and chemical exposure.
Assemble correctly, seek advice, follow wiring, clear table, secure cutters.
Keep hands clear, avoid freehand, use guards, feed correctly, never overreach.
Avoid running between fence/cutter, use proper workpiece, adjust fence carefully.
Use proper circuits, extension cords, and ensure correct voltage and grounding.
Machine must be grounded; use proper outlets, do not modify plugs, consult electrician if unsure.
Use appropriate gauge extension cords for safe power delivery.
Remove protective coating, clean unpainted surfaces, and apply wax.
Assemble the optional stand and attach rubber feet.
Position and secure the router/shaper onto the assembled stand.
Install overhead cutter guard bracket and fence assembly with dust chute.
Operate the power switch and secure it in the 'OFF' position when not in use.
Raise or lower the spindle using the elevation knob and lock it securely.
Adjust fence halves for parallel alignment and side-to-side position.
Use the see-through guard; it moves with workpiece for guidance.
Check and adjust spindle angle to 90 degrees relative to the table surface.
Store wrenches on provided hooks on the machine cabinet.
Adjust table angle to 90 degrees (front/back) to the spindle using leveling nuts.
Insert bits using collets or adapter sleeves and tighten securely with wrenches.
Utilize the starting pin for workpiece support when cutting without the fence.
Mount the overhead cutter guard for operations requiring fence removal.
Install the optional shaper spindle and adjust fences accordingly.
Use the fence for safe and satisfactory straight shaping operations.
Follow rules for smooth collars, workpiece support, and proper feed direction.
Collars can be positioned above, below, or between cutters for various shaping results.
Use starting pin for initial support; always feed against cutter rotation to prevent kickback.
Information on obtaining Delta accessories and parts.
Contact Delta for service, warranty claims, and assistance.
