Delta MultiChoice T27 Series User Manual

MultiChoice
®
Valve Trim
with Diverter
Installation Instructions
Owners Manual
Models T27
Write purchased model number here.
You May Need
THIS VALVE MEETS OR EXCEEDS THE
FOLLOWING STANDARDS: ASME A112.18.1/
CSA B125.1 and ASSE 1016 (Type -P- or -T-).
CAUTION: This system/device must be set by the
installer to ensure safe, maximum temperature.
Any change in the setting may raise the discharge
temperature above the limit considered safe and
may lead to hot water burns.
NOTICE TO INSTALLER: CAUTION!–As the
installer of this valve, it is your responsibility
to properly INSTALL and ADJUST this valve
per the instructions given. This valve does
not automatically adjust for inlet temperature
changes, therefore, someone must make the
necessary Rotational Limit Stop adjustments
at the time of installation and further adjustments
may be necessary due to seasonal water
temperature change. YOU MUST inform the
owner/user of this requirement by following
the instructions. If you or the owner/user are
unsure how to properly make these adjustments
please refer to page 6 and if still uncertain, call
us at 1-800-345-DELTA.
After installation and adjustment, you must afx
your name, company name and the date you
adjusted the Rotational Limit Stop to the caution
label provided and apply or attach the label to
the back side of the closest cabinet door and the
warning label to the water heater. Leave this
Instruction Sheet for the owner’s/user’s
reference.
WARNING: This pressure balanced or
thermostatic bath valve is designed
to minimize the effects of outlet water
temperature changes due to inlet pressure
changes, commonly caused by dishwashers,
washing machines, toilets and the like. It may
not provide protection from hot water burns
when there is a failure of other temperature
controlling devices elsewhere in the
plumbing system, if the rotational limit stop
is not properly set or if the hot water
temperature is changed after the settings are
made or if the water inlet changes
due to seasonal changes.
WARNING: Do not install a shut-off device on
either outlet of this valve. When this type of
device shuts off the water ow, it can defeat
the ability of the valve to balance the hot and
cold water pressures.
107532 Rev. B1
Table of Contents:
Warranties ............................................................................... Page 2
Installation Instructions ........................................................... Pages 3 - 7
Clean and care......................................................................... Page 9
Maintenance ............................................................................ Page 9
Cartridge Summary Reference Sheet ..................................... Page 9
For additional replacement parts, visit www.deltafaucet.com
07/08/2020
3/32"
107532

Delta MultiChoice T27 Series Specifications

General

Brand	Delta
Model	MultiChoice T27 Series
Category	Control Unit
Language	English

Summary

Cartridge Installation

Cartridge Installation Steps

Steps for installing the valve cartridge, including flushing debris and securing the bonnet nut.

Back to Back Installation

Instructions for back to back or reverse installations, including cartridge orientation and lubrication.

Diverter Cartridge Installation

Diverter Cartridge Installation

Procedure for installing the diverter cartridge, ensuring correct alignment and lubrication.

Bonnet Installation

Steps for installing the bonnet nut over the diverter sleeve and threading it into the rough-in body.

Trim Installation

Trim Sleeve Installation

Guide for sliding the trim sleeve over the bonnet, cartridge, and rough-in body.

Escutcheon Installation

Securing the backplate and escutcheon to the rough-in body for finished wall thickness.

Volume Control Handle Installation

Instructions for installing the volume control handle with the lever pointing down.

Rotational Limit Stop Adjustment

Rotational Limit Stop Placement

Placing the rotational limit stop in the volume handle and checking initial temperature.

Temperature Control Knob Securing

Securing the temperature control knob and cover with screws.

Adapter and Handle Installation

Installing the adapter, handle, and securing it with a set screw.

Diverter Handle Installation

Diverter Handle Installation

Sliding the diverter handle onto the trim sleeve and securing it with a set screw.

Diverter Handle Reference Sheet

3 Function Diverter Water Flow

Reference guide for water flow positions for 3-function diverter.

6 Function Diverter Water Flow

Reference guide for water flow positions for 6-function diverter.

Clean and Care

Maintenance

Faucet Leaks from Hand Shower

Instructions for replacing the valve cartridge to fix hand shower leaks.

Helpful Hints for Maintenance

Tips for valve cartridge removal, installation, and periodic inspection due to water contaminants.

Cartridge Summary Reference Sheet