107532 Rev. B
Potential scald or thermal shock injury could result due to cross ow if outlet at the shower
is blocked or restricted (e.g., pause control on hand shower). Be sure to point hand shower
away from you when re-starting ow or install inlet check valves on both supply lines to
prevent possible injury.
Snap temperature control cover over temperature
control knob by rst aligning smaller tab (1) on
cover with receiving slot (2) on temperature knob.
Swing larger tab (3) to engage with snap feature
(4). Note: If dis-assembly is required, reverse
this motion, disengaging larger tab (3) from snap
feature (4) rst.
7
6
Diverter handle Installation
Diverter Handle Installation
Slide diverter handle (1) onto trim sleeve (2).
Using a allen wrench, insert set screw (3) into
handle (1). Applying pressure, insert set screw
cover (4), if included, until properly seated.
5
D.
4
2
1
3
2
1
3
4
To Next Page
Loading...
