9
ASSEMBLY INSTRUCTIONS
3
Pull existing ductwork
into Housing
1
2
3
Insert tab into slot
in Housing
Duct screw(M4X12)
4
4
5
ac
b
2
7. Remove the fan junction box cover . Using
wire nuts (not supplied), connect house wires to
fan wires
as shown in the wiring diagram on
page 5. 14AWG is the smallest conductor that shall
box cover .
8. Insert housing can into the ceiling cut out. Secure
the housing can from below by using 2 long wood
joist.
Hardware
A
Long wood screw
9. Attach the duct connector from the housing can
inside, and secure using the duct screw.
10. Insert fan unit and secure by 3 screws.
be used for branch-circuit wiring. Reattach fan junction
To Next Page
Loading...
Need help?
General
