Delta VFD-MS300 Series User Manual

QUICK SETUP INSTRUCTIONS
FOR VARIABLE SPEED DRIVE
1 PHASE TO 3 PHASE
AND
3 PHASE TO 3 PHASE
Connect Live to R and Neutral to S for single phase input
supply
Connections U/T1, V/T2, W/T3 go to the motor
Connect 3 phase input supply to L1/R, L2/S, L3/T
Connections U/T1, V/T2, W/T3 go to the motor
V/F curve set up
Factory setting is General purpose
HAMILTON PH: 07 847 3374
CHRISTCHURCH PH: 03 666 3374
sales@rotatingmachinery.co.nz
AUCKLAND PH: 09 271 6063
info@brookmtl.co.nz
For remote stop and start connect between DCM
and MI1 (FWD) and MI2 (REV) (DCM is your common)
For remote Potentiometer connect the pot to +10V,
AVI and ACM (common).
Set 00.20 to 2 (Remote Potentiometer)
Set 00.21 to 1 (Remote ON/OFF setting)
Set 02.00 to 1 or 2 (2-wire operation control)
Instructions for Remote Setup
(Remote On/Off and Speed Variation)
Set 02.00 to 3 (3-wire operation control)
VFD-MS300 Series

Delta VFD-MS300 Series Specifications

General

Braking Unit	Built-in
Control Mode	V/F Control, Sensorless Vector Control
Humidity	Less than 90% RH (non-condensing)
Cooling Method	Fan cooling
Enclosure Rating	IP20
Overload Capacity	150% for 1 minute
Communication Interface	RS-485
Protection Features	Overvoltage, undervoltage, overcurrent, overload, short circuit, overheating
Output Voltage	0 to Input Voltage
Power Range	0.2 kW to 22 kW
Operating Temperature	-10°C to 50°C
Storage Temperature	-20°C to 60°C