To Next PageTo Next Page
Need help?Do you have a question about the Delta VFD-EL-W Series and is the answer not in the manual?
Safety precaution: Always disconnect AC input power before wiring.
Safety precaution: DC-link capacitors may retain hazardous voltage even after power is off.
Safety precaution: MOS components are sensitive to static electricity; use anti-static measures.
Safety precaution: Do not modify internal components or wiring of the AC motor drive.
Safety precaution: Ensure proper grounding of the AC motor drive using the ground terminal.
Safety precaution: Avoid installing the drive in high temperature or flammable environments.
Selection of operation modes: communication, digital keypad, or external signals.
Procedure for performing a trial run, including checks and motor rotation direction.
Parameters for selecting frequency command sources and operation command sources.
Parameters for over-voltage, over-current stall prevention, and over-torque detection.
Parameters for setting motor rated current, no-load current, auto-torque compensation, and auto-tuning.
Parameters for communication address, transmission speed, fault treatment, and protocol selection.
Parameters for PID set point selection, input terminals, and proportional/integral/differential gains.
Application-specific parameter settings for speed search, DC brake, energy saving, and multi-step speed.
Flowchart for troubleshooting over-current faults, including checks for short circuits and load.
Flowchart for troubleshooting over-voltage faults, including checks for deceleration time and brake units.
Flowchart for troubleshooting low voltage faults, including power supply and component checks.
Flowchart for troubleshooting overheat faults, including checks for load, fans, and ambient temperature.
Flowchart for troubleshooting overload faults, including checks for settings and load.
Comprehensive flowchart for diagnosing why the motor does not run, covering various checks.
Displays fault names, descriptions, and corrective actions for common faults like Over-current and Over-voltage.
Instructions on how to reset the drive after a fault, using the RESET key or communication.
Formulas for calculating starting capacity and current for single and multiple motor drives.
General
