To Next PageTo Next PageHow to prevent industrial dust problems with Delta VFD-ED DC Drives?
To prevent issues with industrial dust for your Delta DC Drives, install the AC motor drive in a standard cabinet and cover it with a dust cover. Regularly clean the cabinet and ventilation holes to maintain good ventilation.
How to prevent greasy dirt problems with Delta VFD-ED?
To address greasy dirt issues with your Delta DC Drives, install the AC motor drive in a standard cabinet to keep it away from greasy dirt. Regularly clean and remove greasy dirt to prevent damage to the drive.
How to prevent corrosion in Delta DC Drives?
To avoid corrosion problems with your Delta DC Drives, install the AC motor drive in a standard cabinet to keep it away from fluids. Regularly clean the drive to prevent corrosion.
How to prevent fiber dust problems with Delta DC Drives?
To prevent fiber dust problems with your Delta DC Drives, install the AC motor drive in a standard cabinet to keep it away from fiber dust. Make sure to clean and remove fiber dust regularly to prevent damage to the drive.
General| Category | DC Drives |
|---|---|
| Cooling Method | Fan Cooling |
| Enclosure Rating | IP20 |
| Output Voltage | 0 ~ Input Voltage |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Phase Loss |
| Communication Interface | RS-485 |
| Operating Temperature | -10°C ~ +50°C (14°F ~ 122°F) |
| Storage Temperature | -20°C |
| Series | VFD-ED Series |
Explains the RFI switch function to suppress interference on the power line.
Provides dimensional drawings and specifications for different frame sizes.
Specifies the minimum required clearances for proper ventilation and heat dissipation.
Details airflow requirements and power dissipation for cooling AC motor drives.
Illustrates the typical wiring connections for AC motor drives.
Provides essential precautions and checks to avoid wiring mistakes.
Illustrates the wiring diagrams for main circuit terminals for different frames.
Details wire gauge and tightening torque for main circuit terminals across frames.
Provides specifications for wire gauge and torque force for terminal sockets.
Details terminal functions and default settings for control circuits.
Provides recommended model selection for brake resistors and units.
Details external EMC filter models and recommendations for noise reduction.
Describes the digital keypad KPC-CC01, its functions, and installation.
Provides instructions for detaching and attaching the top cover for option card installation.
Summarizes general control characteristics, protection features, and certifications.
Details environmental conditions for operation, storage, and transportation.
Details the keyboard layout, functions, and LED indicators.
Explains the functions of the digital keypad KPC-CC01, including parameter setup.
Lists and describes fault codes and their corrective actions.
Provides step-by-step guidance for auto-tuning induction motors.
Details the descriptions and procedures for various tuning steps.
Provides a summary of drive parameters including identity codes and rated current.
Summarizes protection parameters for low voltage, phase loss, and over-torque.
Lists communication parameters like address, speed, and protocol settings.
Details parameters related to encoder selection and feedback signal.
Details parameters specific to Induction Motors (IM), including auto-tuning.
Details protection parameters such as low voltage, over-current, and over-torque.
Details parameters for communication settings like address, speed, and protocol.
Describes parameters for encoder selection, feedback signal, and stall/slip settings.
Provides guidelines for regular maintenance checks on ambient environment, voltage, keypad, and mechanical parts.
Addresses common issues related to incorrect wire installation or poor wiring.
Explains the Safe Torque Off (STO) function and terminal operations.
Illustrates the internal safety circuit and drive control circuit wiring diagrams.
Lists and describes fault codes associated with the Safe Torque Off function.
Discusses grounding methods for EMC compliance, including protective and functional grounding.
Explains electrostatic and electromagnetic shielding principles and examples.
Details the use of electromagnetic filters for reducing conducted interference.
Describes Modbus communication protocols, including ASCII and RTU modes.
Provides a list of Modbus addresses for AC motor drive parameters.
