Delta VFD-EL-W Series - Basic Parameters

Chapter 4 Parameters｜VFD-EL-W
41
01 Basic Parameters
 You can set this parameter during operation.
Pr.
Parameter Name
Setting Range
Default
01.00
Max. Operation Frequency
50.00–400.0 Hz
60.00/
50.00
01.01
Motor Rated Frequency
0.10–400.0 Hz
60.00/
50.00
01.02
Motor Rated Voltage
230V models: 0.1–255.0 V
220.0/
230.0
460V models: 0.1–510.0 V
380.0/
400.0
01.03
Mid-Point Frequency
Setting
0.10–400.0 Hz
1.50
01.04
Mid-Point Voltage Setting
230V models: 0.1–255.0 V
460V models: 0.1–510.0 V
10.0
20.0
01.05
Min. Output Frequency
Setting (Hz)
0.10–400.0 Hz
1.50
01.06
Min. Output Voltage
Setting
230V models: 0.1–255.0 V
460V models: 0.1–510.0 V
10.0
20.0
01.07
Output Frequency Upper
Limit
0.1–120.0%
110.0
01.08
Output Frequency Lower
Limit
0.0–100.0%
0.0

01.09
Acceleration Time 1
0.1–600.0 sec./ 0.01–600.00 sec.
10.0

01.10
Deceleration Time 1
0.1–600.0 sec./ 0.01–600.00 sec.
10.0

01.11
Acceleration Time 2
0.1–600.0 sec./ 0.01–600.00 sec.
10.0

01.12
Deceleration Time 2
0.1–600.0 sec./ 0.01–600.00 sec.
10.0

01.13
JOG Acceleration Time
0.1–600.0 sec./ 0.01–600.00 sec.
1.0

01.14
JOG Deceleration Time
0.1–600.0 sec./ 0.01–600.00 sec.
1.0

01.15
JOG Frequency Setting
0.10–400.0 Hz
6.00
01.16
Auto-Acceleration / Auto-
Deceleration Setting
0: Linear acceleration and deceleration
1: Auto-acceleration and linear deceleration
2: Linear acceleration and auto-deceleration
3: Auto-acceleration and auto-deceleration (set by
loads)
4: Auto-acceleration and auto-deceleration (set by
acceleration/ deceleration time setting)
0
01.17
S-Curve Acceleration Time
Setting
0.0–10.0 sec./ 0.00–10.00 sec.
0.0