Delta VFD040C43A-21 - Page 1014

Chapter 14 Fault Codes and DescriptionsC2000 Plus
14-111
ID
Display on LCD Keypad
Fault Name
Fault Descriptions
184
No motion control
(NoMo)
Cannot use synchronization cycle command mode
Action and Reset
Action condition
Use synchronization command mode without EMC-MC01
Action time
Act immediately
Fault treatment parameter
N/A
Reset method
Manual reset
Reset condition
Reset immediately
Record
Yes
Cause
Corrective Actions
Not using EMC-MC01
Use motion control card EMC-MC01 when using synchronization cycle mode.