Chapter 10 Digital KeypadC2000 Plus
10-26
Other displays
When a fault occurs, the screen display shows the fault or warning:
1. Press the STOP / RESET key to reset the fault code. If there is no response, contact your local distributor or
return the unit to the factory. To view the fault DC bus voltage, output current and output voltage, press MENU
and then choose 6: Fault Record.
2. After resetting, if the screen returns to the main page and shows no fault after you press ESC, the fault is
cleared.
3. When the fault or warning message appears, the LED backlight blinks until you clear the fault or warning.
Optional accessory: RJ45 Extension Lead for Digital Keypad
Part No. Description
CBC-K3FT RJ45 extension lead, 3 feet (approximately 0.9 m)
CBC-K5FT RJ45 extension lead, 5 feet (approximately 1.5 m)
CBC-K7FT RJ45 extension lead, 7 feet (approximately 2.1 m)
CBC-K10FT RJ45 extension lead, 10 feet (approximately 3 m)
CBC-K16FT RJ45 extension lead, 16 feet (approximately 4.9 m)
NOTE: When you need communication cables, buy non-shielded, 24 AWG, four-wire twisted pair, 100 ohms
communication cables.
To Next Page
Loading...
Need help?
General