Delta VFD075C43A User Manual

Chapter 1 IntroductionC2000 Series
1-1
Chapter 1 Introduction
1-1 Receiving and Inspection
After receiving the AC motor drive, please check for the following:
1. Please inspect the unit after unpacking to assure it was not damaged during shipment. Make sure that
the part number printed on the package corresponds with the part number indicated on the
nameplate.
2. Make sure that the voltage for the wiring lie within the range as indicated on the nameplate. Please
install the AC motor drive according to this manual.
3. Before applying the power, please make sure that all the devices, including power, motor, control
board and digital keypad, are connected correctly.
4. When wiring the AC motor drive, please make sure that the wiring of input terminals “R/L1, S/L2, T/L3”
and output terminals”U/T1, V/T2, W/T3” are correct to prevent drive damage.
5. When power is applied, select the language and set parameter groups via the digital keypad
(KPC-CC01). When executes trial run, please begin with a low speed and then gradually increases
the speed untill the desired speed is reached.
1-2 Nameplate Information
MODEL:VFD007C43A
INPUT:
Normal Duty: 3PH 380-480V 50/60Hz 4.3A
Heavy Duty: 3PH 380-480V 50/60Hz 4.1A
OUTPUT:
Ver si on :
FREQU ENCY RA NGE:
Normal Duty: 3PH 0-480V 3A 2.4KVA 1HP
Heavy Duty: 3PH 0-480V 2.9A 2.3KVA 1HP
Normal Duty: 0 -59 9Hz
Heavy Duty: 0-300Hz
VX.XX
007C43A7T14300002
DE LTA EL ECTRONICS. INC .
MA DE IN XXXXXX X
AC Drive Model
Input Voltage/Current
Output Voltage/Current
Frequency Range
Firmware Version
Certif cations
Serial Number
Enclosure type (IPXX)
i

Delta VFD075C43A Specifications

General

Brand	Delta
Model	VFD075C43A
Category	Media Converter
Language	English

Summary

1-1 Receiving and Inspection

1-2 Nameplate Information

1-3 Model Name

1-4 Serial Number

1-5 RFI Jumper

RFI Jumper Function and Frame-Specific Installation

Explains RFI jumper purpose, installation for Frames A-C, and handling for Frame D0-H.

Grounding and System Type Considerations

Details on ground connection, isolating power, and requirements for floating/asymmetric systems.

1-6 Dimensions

Frame A Dimensions

Detailed physical dimensions and mounting hole specifications for Frame A AC drives.

Frame B Dimensions

Detailed physical dimensions and mounting hole specifications for Frame B AC drives.

Frame C Dimensions

Detailed physical dimensions and mounting hole specifications for Frame C AC drives.

Frame D0 Dimensions

Physical dimensions and mounting hole specifications for Frame D0-1 and D0-2 AC drives.

Frame D Dimensions

Physical dimensions and mounting hole specifications for Frame D1 and D2 AC drives.

Frame E Dimensions

Physical dimensions and mounting hole specifications for Frame E1 and E2 AC drives.

Frame F Dimensions

Physical dimensions and mounting hole specifications for Frame F1 and F2 AC drives.

Frame G Dimensions

Physical dimensions and mounting hole specifications for Frame G1 and G2 AC drives.

Frame H Dimensions

Physical dimensions and mounting hole specifications for Frame H1, H2, and H3 AC drives.