Chapter 12 Description of Parameter SettingsC2000-HS
12.1-00-14
Digital Operator (Keypad) Frequency Command Memory
Default: Read Only
Settings Read only
If the keypad is the frequency command source, when Lv or Fault occurs, this parameter stores
the current frequency command.
User-Defined Characteristics
Default: 0
Settings bit0–3: user-defined decimal place
0000b: no decimal place
0001b: one decimal place
0010b: two decimal place
0011b: three decimal place
bit 4–15: user-defined unit
000xh: Hz
001xh: rpm
002xh: %
003xh: kg
004xh: m/s
005xh: kW
006xh: HP
007xh: ppm
008xh: 1/m
009xh: kg/s
00Axh: kg/m
00Bxh: kg/h
00Cxh: lb/s
00Dxh: lb/m
00Exh: lb/h
00Fxh: ft/s
010xh: ft/m
011xh: m
012xh: ft
013xh: degC
014xh: degF
015xh: mbar
016xh: bar
017xh: Pa
018xh: kPa
019xh: mWG
01Axh: inWG
01Bxh: ftWG
To Next Page
Loading...