Chapter 5 Methods of Anomaly Diagnosis |V FD-VJ-
5-14
Reset Alarm:
Once the issue that tripped the system and triggers the alarm is eliminated, one can resume the
system to normal status by pressing the RESET key on the digital keypad (as shown in the figure) to
set the external terminal to "Anomaly reset command" and sending the command by turning on the
terminal or via communication. Before any anomaly alarm is resolved, make sure the operation signal
is at open circuit status (OFF) to avoid immediate machine running upon anomaly reset that may case
mechanical damage or personnel casualty.
1
1
2
3
4
5
Stop/ Reset key:
Press this button to
stop running and
reset abnormality
.
To Next Page
Loading...