Chapter 3. Machine Adjustment Procedure | VFD-VJ
3-21
Slave reverse operation for depressurization
Setting value
of Pr.03-21
0: Disable
1: Enable
Limit for the Slave reverse depressurization torque
Setting value
of Pr.03-16
0~500%
Shut off the power and the re-supply power for the Slave, and then set the Slave in the speed
control mode
Speed Control Mode
Setting value
of Pr.00-09
0: Speed control
1: Pressure control
In this case, the Master can be tuned according to the Step 3 – Step 8 described above
To Next Page
Loading...