Delta VFD25AMS43ANSAA - Page 234

Chapter 11 Summary of Parameter SettingsMS300
225
Pr.
Explanation
Settings
Default
03-19
Signal Loss Selection for
Analog Input 4–20 mA
0: Disable
1: Continue operation at the last frequency
2: Decelerate to 0 Hz
3: Stop immediately and display “ACE”
0

03-20
AFM Multi-Function
Output
0: Output frequency (Hz)
1: Frequency command (Hz)
2: Motor speed (Hz)
3: Output current (rms)
4: Output voltage
5: DC bus voltage
6: Power factor
7: Power
8: Output torque
9: AVI
10: ACI
12: Iq current command
13: Iq feedback value
14: Id current command
15: Id feedback value
16: Vq-axis voltage command
17: Vd-axis voltage command
18: Torque command
19: PG2 frequency command
20: CANopen analog output
21: RS-485 analog output
22: Communication card analog output
23: Constant voltage output
0

03-21
AFM Analog Output Gain
0.0–500.0%
100.0

03-22
AFM Analog Output in
REV Direction
0: Absolute value in output voltage
1: Reverse output 0 V; forward output 0–10 V
2: Reverse output 5–0 V; forward output 5–10 V
0

03-27
AFM Output Bias
-100.00–100.00%
0.00

03-28
AVI Terminal Input
Selection
0: 0–10 V (Pr.03-63–Pr.03-68 is valid)
3: -10–10 V (Pr.03-69–Pr.03-74 are valid)
0

03-29
ACI Terminal Input
Selection
0: 4–20 mA
1: 0–10 V
2: 0–20 mA
0
03-30
PLC Analog Output
Terminal Status
Monitor the status of the PLC analog output terminals
bit 0: AFM
Read only