Delta VFD25AMS43ANSAA - Industry Application Parameters

Chapter 12 Descriptions of Parameter SettingsMS300
441
13 Industry Application Parameters
 You can set this parameter during operation.
13-00
Industry-Specific Parameter Application
Default: 00
Settings
00: Disabled
01: User-defined parameter
02: Compressor
03: Fan
04: Pump
05: Conveyor
06: Machine tool
07: Packing
08: Textiles
10: Logistics
11: Tension PID
12: Tension PID + master / auxiliary frequency
 NOTE: after you select the macro, some of the default values adjust automatically according to
the application selection.
 Setting 02: Compressor
The following table lists the relevant compressor setting application parameters.
Pr.
Parameter Name
Settings
00-11
Speed control mode
0 (IMVF control mode)
00-16
Load selection
0 (Normal load)
00-17
Carrier frequency
Default setting
00-20
Master frequency command source
(AUTO, REMOTE)
2 (External analog input)
00-21
Operation command source
(AUTO, REMOTE)
1 (External terminals)
00-22
Stop method
0 (Ramp to stop)
00-23
Motor direction control
1 (Disable reverse)
01-00
Motor 1 maximum operation frequency
Default setting
01-01
Rated / base frequency of motor 1
Default setting
01-02
Rated / base voltage of motor 1
Default setting
01-03
Mid-point frequency 1 of motor 1
Default setting
01-04
Mid-point voltage 1 of motor 1
Default setting
01-05
Mid-point frequency 2 of motor 1
Default setting
01-06
Mid-point voltage 2 of motor 1
Default setting
01-07
Minimum output frequency of motor 1
Default setting
01-08
Minimum output voltage of motor 1
Default setting
01-11
Output frequency lower limit
20 (Hz)
01-12
Acceleration time 1
20 (sec.)