Chapter 10 Digital KeypadC2000-HS
10-7
20. Output frequency upper limit
(Pr.01-10)
21. Output frequency lower limit
(Pr.01-11)
22. Acceleration time 1 (Pr.01-12)
23. Deceleration time 1 (Pr.01-13)
24. Over-voltage stall prevention
(Pr.06-01)
25. Derating protection (Pr.06-55)
26. Speed tracking during start-up
(Pr.07-12)
27. Emergency stop (EF) & force to stop
selection (Pr.07-20)
28. Torque command filter time
(Pr.07-24)
29. Slip compensation filter time (Pr.07-25)
30. Torque compensation gain (Pr.07-26)
31. Slip Compensation Gain (Pr.07-27)
2. SVC Mode
01: Password Decoder
Items
1. Parameter protection password input
(Pr.00-07)
2. Parameter protection password setting
(Pr.00-08)
3. Control mode (Pr.00-10)
4. Speed control mode (Pr.00-11)
5. Load selection (Pr.00-16)
6. Carrier frequency (Pr.00-17)
7. Master frequency command (AUTO)
source / Source selection of the PID
target (Pr.00-20)
8. Operation command (AUTO) source
(Pr.00-21)
9. Stop method (Pr.00-22)
10. Digital keypad STOP function
(Pr.00-32)
11. Max. operation frequency (Pr.01-00)
12. Output frequency of motor 1
(Pr.01-01)
13. Output voltage setting of motor 1
(Pr.01-02)
14. Min. output frequency of motor 1
(Pr.01-07)
15. Min. output voltage of motor 1
(Pr.01-08)
16. Output frequency upper limit
(Pr.01-10)
17. Output frequency lower limit
(Pr.01-11)
18. Acceleration time 1 (Pr.01-12)
19. Deceleration time 1 (Pr.01-13)
20. Full-load current for induction motor 1
(Pr.05-01)
21. Rated power for induction motor 1
(Pr.05-02)
22. Rated speed for induction motor 1
(Pr.05-03)
23. Number of poles for induction motor 1
(Pr.05-04)
24. No-load current for induction motor 1
(Pr.05-05)
25. Over-voltage stall prevention
(Pr.06-01)
26. Over-current stall prevention during
acceleration (Pr.06-03)
To Next Page
Loading...
Need help?
General