Deltec PowerRite Pro User Manual

Iii
a
L a
-
ON ONLED
This green LED is on when output voltage is
available at the rear receptacles.
AC Input LEDs
The three AC Input LEDs describe line
conditions.
Top LED: Red. This LED is on when the line is
too high ( overvoltage condition) and the UPS is
in battery operation. When the battery is used
up, the LED flashes for 10 minutes. After the
normal line returns, the LED also flashes until
you push reset. If the normal line returns before
battery shutdown, the LED turns off.
Middle LED: Green. This LED is on when the
line is OK.
Bottom LED: Red. This LED is on when the line
is too low ( undervoltage condition) and the UPS
is in battery operation. When the battery is used
up, the LED flashes for 10 minutes. After the
normal line returns, the LED also flashes until
you push reset. If the normal line returns before
battery shutdown, the LED turns off.
@) Site Wiring Fault LED
The Site Wiring Fault LED turns red if either the
ground wire connection does not exist or the
line and neutral wires are reversed in the line
receptacle (the site wiring fault indicator is
disabled on 208 V models). The LED stays on
until you fix or disable the condition using the
DIP Switches (see the DIP Switch Configuration
tables in Section 2).
PawerRite Pro UPS ♦ 05140136~60 ♦ E 23

Deltec PowerRite Pro Specifications

General

Brand	Deltec
Model	PowerRite Pro
Category	UPS
Language	English