DEMA Nitro Plus User Manual

I-1205
Rev. B-43816
Page 7 of 13
3/23/2018
Modify Programming
When modifying the programming of the unit. Use the flow chart below for modifications. The menus change slightly
when modifying the programming.
Company Name Press and hold “Enter” Button for 3 Seconds until backlight comes on
Press 
Language English, Spanish, French, Portuguese
Press 
Rack Count Show Rack count
Press 
Det. SP Input Det. C = Concentration or P = Probeless SP= Set point Input & probe reading
Press 
Modify Program Enter Code
When Concentration is chosen
When Probeless Door is
chosen
When Probeless Conveyor is
chosen
Concentration Set Point 0-1000 Recharge Time 1s – 5 min Recharge Time 1s – 5min
Press  Press  Press 
Feed Rate 0-10 Dead Cycles 0-5 Dwell Time 1s – 10 min
Press  Press  Press 
Feed Limit 5s – 10 min Initial Charge 1s – 10 min Initial Charge 1s – 10 min
Press  Press  Press 
Alarm Delay 5s - 10 min
Charge Activate Off-60s
Charge Clock 5 min – 16 hrs
Press 
Initial Charge Activate will
determine the length of the
rinse trigger that instigates an
initial charge while in probe-less
mode.
Charge Clock - If no triggers are
received for this length of time, the
next wash trigger will give an initial
charge
Alarm Volume 0-10
Press 
Rinse Speed 0-100%
Press 
Rinse Delay 0-15s Door Mode Only
Press 
Rinse Limit 15s - 30s Door Mode Only
Press 
Rinse Length 5s-75s Conveyor and Door/Detergent Trigger only Modes
Press 
Sanitizer Speed 0-100%
Press 
Control Mode Press Enter, then select using arrows Concentration (Probe) or Probe-less
Press 
Machine Type Press Enter, then select using arrows Conveyor or Door.
Press 
Trigger Mode Press Enter, then select Detergent/Rinse or Rinse Only or Detergent Only
Press 
Company Name
Press Enter, use arrows to change characters, use sanitizer prime and exit to move
cursor left and right.
Press 
Rack Count Press Enter, then Exit to Reset Rack Count
Press 
Enter New Code Enter 4 digit code, use sanitizer prime button to move cursor
Press 
Control Mode Reverts back to beginning of programming

DEMA Nitro Plus Specifications

General

Brand	DEMA
Model	Nitro Plus
Category	Dispenser
Language	English