DEMA Nitro Plus User Manual

I-1205
Rev. B-43816
Page 6 of 13
3/23/2018
Initial Programming
The programming of this unit is done through the control board, display, and buttons on the front of the unit.
Programming of the unit is as follows:
Company Name Press and hold “Enter” Button for 3 Seconds until backlight comes on
Press 
Language English, Spanish, French, Portuguese
Press 
Rack Count Show Rack count
Press 
Det. SP Input Det. C = Concentration or P = Probeless SP= Set point Input & probe reading
Press 
New Program Press Enter
Control Mode Press Enter, then select using arrows Concentration (Probe) or Probe-less
Press 
Machine Type Press Enter, then select using arrows Conveyor or Door.
Press 
Trigger Mode Press Enter, then select Detergent/Rinse or Rinse Only or Detergent Only
Press 
When Concentration is chosen
When Probeless Door is
chosen
When Probeless Conveyor is
chosen
Concentration Set Point 0-1000 Recharge Time 1s – 5 min Recharge Time 1s – 5min
Press  Press  Press 
Feed Rate 0-10 Dead Cycles 0-5 Dwell Time 1s – 10 min
Press  Press  Press 
Feed Limit 5s – 10 min Initial Charge 1s – 10 min Initial Charge 1s – 10 min
Press  Press  Press 
Alarm Delay 5s - 10 min
Charge Activate Off-60s
Charge Clock 5 min – 16 hrs
Press 
Initial Charge Activate will
determine the length of the
rinse trigger that instigates an
initial charge while in probe-less
mode.
Charge Clock – If no triggers are
received for this length of time, the
next wash trigger will give an initial
charge.
Alarm Volume 0-10
Press 
Rinse Speed 0-100%
Press 
Rinse Delay 0-15s Door Mode Only
Press 
Rinse Limit 15s - 30s Door Mode Only
Press 
Rinse Length 5s-75s Conveyor and Door/Detergent Trigger only Modes
Press 
Sanitizer Speed 0-100%
Press 
Company Name
Press Enter, use arrows to change characters, use sanitizer prime and exit to move
cursor left and right.
Press 
Rack Count Press Enter, then Exit to Reset Rack Count
Press 
Enter New Code Enter 4 digit code, use sanitizer prime button to move cursor
Press 
Control Mode Reverts back to beginning of programming
Inductive Probe – With the inductive probe there are a several settings that can be further changed to help make the
inductive probe more useful. For detailed information on those settings, please see instruction sheet I889 that comes
with the Inductive Probe Kit (82.28.1). For further assistance contact DEMA Technical Service.

DEMA Nitro Plus Specifications

General

Brand	DEMA
Model	Nitro Plus
Category	Dispenser
Language	English