Original
1 page(s) Page 1
EC conformity declaration for a machine
in accordance with Directive 2006/42/EC, Annex IIA
Ident. no.
199 610 44
Issue 1209 EN
# = Modifications compared to
previous issue
Normung DCC
Class. no.
715 IS 817
Reproduction in whole or in part only with prior consent of Demag Cranes & Components GmbH, D-58286 Wetter Subject to change. Not liable for errors or omissions.
Hereby we,
Demag Cranes & Components GmbH
Ruhrstraße 28, D-58300 Wetter
declare that the electrically driven hoist unit for lifting loads
Demag DC chain hoist
Type:
Bauformschlüssel
Serial no.:
Fabriknummer
ready for service – as a series product or produced to order - with cable-connected
control pendants / wireless controls
complies with all relevant requirements of the
EC Machinery Directive 2006/42/EC.
The safety objectives of the Low Voltage Directive 2006/95/EC are achieved.
The product additionally complies with the following relevant directives/provisions:
2004/108/EC EC EMC Directive
Applied harmonised standards, in particular
EN 14492-2 Cranes - Power-driven winches and hoists - Part 2:
Power-driven hoists
EN 60204-32 Safety of Machinery – Electrical equipment for
machinery, Part 32: Requirements for hoists
The relevant technical documentation according to Annex VII Part A of Directive
2006/42/EC has been compiled and shall be made available to authorised national
authorities by the designated authorised representative in response to a justified
request.
Authorised representative for technical documentation
Hans-Jörg Böttcher, Demag Cranes & Components GmbH
Ruhrstraße 28, D-58300 Wetter
Wetter, 29.12.09
Place and date of issue
ppa. Dr. Harkort ppa. Schulte
Wetter Factory Manager HT/AT Engineering/Development
To Next Page
Loading...
