64
ENGLISH
• If no station broadcasting the designated program type is found
when all the frequencies are searched, “NO PROGRAMME” is
displayed.
(7) PTY search
Use this function to find RDS stations broadcasting a designated program type (PTY).
For a description of each program type, refer to “Program Type (PTY)”.
1
Set the band to “FM”.
2
Press the RDS button until “PTY
SEARCH” appears on the display.
Remote control unit
3
Watching the display, press the PTY
button to call out the desired program
type.
Remote control unit
5
The station name is displayed on the display after searching
stops.
• If no TP station is found when all the frequencies are searched,
“NO PROGRAMME” is displayed.
(8) TP search
Use this function to find RDS stations broadcasting traffic program (TP stations).
1
Set the band to “FM”.
2
Press the RDS button until “TP
SEARCH” appears on the display.
Remote control unit
4
The station name is displayed on the display after searching
stops.
• When the RT mode is turned on while an RDS radio station not
offering an RT service is tuned in, “NO TEXT DATA” is displayed on
the display, then the mode automatically switches to the PS mode.
• In the same way, the mode automatically switches to the PS mode
when the RT service is finished. In this case, the mode
automatically switches from the PS mode back to the RT mode
when an RT broadcast is resumed.
• The RT mode cannot be set in the AM band or for FM stations not
offering RDS broadcasts.
• To turn the RT mode off, press the RT button and switch to the
desired display mode. (Refer to page 63.)
(9) RT (Radio Text)
“RT” appears on the display when radio text data is received.
1
To turn the RT mode on, press the RT
button on the remote control unit until
the RT indicator is lit.
2
When the station currently tuned in is offering a radio text
message service, the message scrolls on the display.
To Next Page
Loading...
