51
ENGLISH
[2] 2-channel mode settings
• When 2-channel signals are input, one of two playback modes can be selected and set according to the 2-channel mode setting, Virtual 1 or
Virtual 2. (The Virtual 1 mode is set by factory default.)
Virtual 1 : 2-channel sources are played in virtual surround using Dolby Pro Logic II Cinema processing.
Virtual 1 : 2-channel sources are played in virtual surround using Dolby Pro Logic processing.
B
BAND
PHONES
VOLUME
ON / STANDBY
DVD SURROUND RECEIVER ADV-M71
TONE /SDB
FUNCTION
MENU/ SET
+
-
SURROUND /SELECT
PUSH
-
PARAM.
VIRTUAL SPEAKER
1,2,3
RC-936
A / V
3
STAT U S
RETURN
ANGLE AUDIO
SUB TITLE
SETUP TONE /SDB
FUNCTIONSURROUNDINPUT MODETEST TONE
DVD
ENTER
MUTING
DISPLAY MENU
TOP MENU
SYSTEM MD
CDR TAPE
TUNER TV / VCR
SURROUND
PARAMETER
CH SELECT
-
+
VCR CH
IN
/
SURR.
IN
/
SURR.
DVD
9
8
21
76
+
-
1
3
2
NOTES:
• The 2-channel mode cannot be set when Dolby Digital or DTS
5.1-channel signals.
• The 2-channel mode is set and stored in the memory individually
for the different functions.
1
Set the surround mode to “DOLBY VIRTUAL SPEAKER”
(“DOLBY VS”).
• The normal display reappears after the surround mode is
displayed.
SURROUND / SELECT
PUSH
-
PARAM.
Main unit Remote control unit
2
Press the SURROUND PARAMETER
button and select the 2-channel
mode.
SURROUND / SELECT
PUSH
-
PARAM.
Main unit
This can be selected if there is no
digital input signal, if the digital
input is a PCM or Dolby Digital 2-
channel signal and if the input is
analog.
Remote control unit
3
Turn the SURROUND/SELECT control on the main unit or use
the
0
and
1 cursor buttons on the remote control unit to
select the desired 2-channel mode.
SURROUND / SELECT
PUSH
-
PARAM.
Main unit Remote control unit
Once the surround parameters have been set, stop operating the
buttons. After several seconds, the normal display reappears and
the settings are automatically entered
To Next Page
Loading...
